SIMATIC RTU3030C battery module

• Заказные данные
  (1)
• Информационные материалы

  Информационные материалы

  The battery module has been designed for the battery power supply of the compact telecontrol unit SIMATIC RTU3030C. It consists of the battery module housing and a battery holder. The batteries are not included in the scope of delivery (see "Design" section).

  The self-powered RTU3030C is particularly suited for the monitoring and control of remote stations that are not connected to an energy supply network. It can independently collect data from connected sensors with time stamps, preprocess the data, and transfer it to a control center by means of mobile radio. Thanks to optimization of energy consumption, the RTU3030C can be supplied via a battery, accumulator or solar panel. Supply via a 12 - 24 V DC power supply is also possible. A battery power supply can be used exclusively or in addition to other power supply options.

  Область применения

  The battery module can be used as sole energy supply source of the RTU3030C as well as in combination with an external direct current source (e.g. accumulator and/or solar panel). For battery operation only, the use of two battery modules is strongly recommended since this is the only way to ensure uninterrupted operation when the total battery capacity is fully utilized simultaneously.

  Дизайн

  • Rugged, compact plastic enclosure for the temperature range -40 °C to +70 °C
  • Easy mounting on a standard DIN rail
  • Plug for direct connection to the SIMATIC RTU3030C
  • Connection socket for connection of a secondary battery module

  The battery module housing is equipped with a holder for two batteries. The batteries are not included in the scope of delivery. For use in the battery module housing of the RTU3030C, two lithium-metal batteries that can withstand high current (primary cells, not rechargeable) are needed in each case.

  The batteries must meet the following requirements:

  • Electrical data
    • Nominal voltage (V_nom): 3.6 V
    • Min. continuous current: 1800 mA
    • Min. pulse current: 4000 mA
    • Important: Protection against short circuit (protection against over-temperature): Fuse or temperature-dependent resistor
  • Geometric data
    • Size according to ANSI: D (mono)
    • Maximum diameter: 33.4 mm
    • Maximum height: 61.5 mm
  • Approved battery types:
    • SAFT, LSH20

  Особенности

  

  • Connection of the battery module without wiring effort
    The battery module is inserted on the left side of the SIMATIC RTU3030C and connected to the RTU without wiring effort by means of a connector on the side.
  • Easy battery replacement on site
    If necessary, the battery can be easily replaced by the service personnel on site.
  • Flexible energy supply concept
    Up to two battery modules can be connected to the RTU3030C. In addition to the battery modules, the external 12 ... 24 V DC voltage input (e.g. with a connected solar panel) can be used for power supply of the RTU. The battery module serves as spare in this case. The different energy supply options support the flexible used in different areas of application.
  • Battery replacement without loss of data
    For battery replacement, the RTU3030C can be switched to a safe state. This enables a battery replacement without the loss of data. When two batteries are used, battery replacement can also take place without any interruptions.
  • Reliable use under harsh environmental conditions
    The battery module housing is designed for use in harsh environmental conditions. When fitted with the approved battery types, it supplies the SIMATIC RTU3030C reliably with energy, even in the extended temperature range from -40 °C to +70 °C.
  • Status monitoring of the battery
    When two battery modules are connected to the RTU3030C, the RTU automatically switches to the secondary battery module when a critical charging status has been reached. This guarantees uninterrupted operation and ensures that the first battery is completely discharged. The user can also be notified when the charging status drops below a defined threshold.

  Технические данные

  Order number		6NH3112-3BA00-1XX2
  Product type designation		Battery housing for autarkic RTU
  Electrical data
  Number of electrical connections		2
  Type of electrical connection		Sockets for connecting to SIMATIC RTU3030C and another battery enclosure
  Mechanical data
  Material		plastic
  Permitted ambient conditions
  Ambient temperature
  ● during storage		-40 ... +70 °C
  ● during transport		-40 ... +70 °C
  Relative humidity
  ● at 30 °C without condensation during operation maximum		95 %
  Protection class IP		IP20
  Design, dimensions and weight
  Design		compact
  Width		45 mm
  Height		100 mm
  Depth		75 mm
  Net weight		132 g